Axxess HYKIA-01, Руководство по установке

Страница: 4 / 12

4
10-pin to 24- and 18-pin connector
1. From the 10-pin harness:
• Connect the male 3.5mm jack to the aftermarket radio’s SWC input
(if equipped)
If you are using an Eclipse or Kenwood radio, plug the female 3.5mm connector
with the
Brown and Brown/White wires into the male 3.5mm connector of the
ASWC harness.
*For Kenwood/JVC radios:
Connect the Kenwood/JVC SWC wire (normally Blue/Yellow) to the Brown wire
of the ASWC. Isolate and tape the Brown/White wire, it will not be used.
*For Eclipse radios:
Connect the Eclipse SWC wires (Normally Brown and Brown/Black) to the
Brown and Brown/White wires of the ASWC. Brown goes to Brown and
Brown/White goes to Brown/Black.
For all other radios, plug in the male 3.5mm connector of the ASWC into the
back of the aftermarket radio, designated for an external SWC control interface.
Please refer to the aftermarket radios manual if you are in doubt where the
3.5mm connector of the ASWC goes.
Connections on the interface (cont.)