Installation instructions for part AXGMLN-03
REV
. 1/21/2020 INST
AXGMLN-03
K
NOWLEDGE IS
P
OWER
E
nhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
®
Metra recommends MECP
certified technicians
axxessinterfaces.com
•
metraonline.com
© COPYRIGHT 2020 METRA ELECTRONICS CORPORATION
Axxess Integrate
IMPORTANT
If you are having difficulties with the
installation of this product, please call our
Tech Support line at
1-800-253-TECH
.
Before doing so, look over the instructions a
second time, and make sure the installation
was performed exactly as the instructions
are stated. Please have the vehicle apart
and ready to perform troubleshooting steps
before calling.
Adjusting the AXGMLN-03
Chime level adjustment:
• Turn the vehicle off but leave the keys in the ignition. Open the driver’s door and leave it open;
chimes will be heard.
• Wait 10 seconds, and then with a small flat-blade screwdriver, adjust the potentiometer clockwise
to raise the chime level; counterclockwise to lower the chime level.
Note:
The potentiometer is located on the side of the interface where the 16-pin harness with
stripped leads is connected to.
• When the chime is at the desired level, remove the keys from the ignition. This will lock the chime
level in at its current level.
OnStar level adjustment:
• Press the OnStar button to activate it.
• While OnStar is speaking, press the VOLUME UP or VOLUME DOWN buttons on the steering wheel
to raise or lower the OnStar level.
• If the vehicle does not come equipped with steering wheel controls, locate the
Black/Yellow
wire
on the AXGMLN-03 harness.
• While OnStar is speaking, tap the
Black/Yellow
wire to ground. Once the OnStar level is set, it will
stay at that level until the
Black/Yellow
wire is tapped to ground again.
