Axxess AX-AU12-SWC, Руководство по установке

Страница: 2 / 12

2
CONNECTIONS TO BE MADE
(LD-BX-AU1 APPLICATIONS)
Attention! This interface will work with models that are equipped with or without a Bose ampli-
fier. Please follow the instructions carefully for your model vehicle. Failure to do so will result in
improper sound. If you are unsure if your vehicle is equipped with a Bose amplifier or not, please
contact your local dealership.
For models equipped
with
a Bose sound system:
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
• Connect the
Orange
wire to the illumination wire. If the aftermarket radio does not have an
illumination wire, tape off and disregard the Orange wire.
• Connect the Blue/White wire to the amp turn on wire. This wire must be connected to hear
sound from the factory amplifier.
Note: There is a Blue wire on the LD-BX-AU1 harness to connect as well.
The following (2) wires are for multimedia/navigation radios that require these wires. If not
required, tape them off and disregard them.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.
• Tape off and disregard the following (9) wires, they will not be used in this application:
Blue/Pink , Green , Green/Black , Purple , Purple/Black , White , White/Black , Gray and Gray/Black.
From the LD-BX-AU1 harness to the aftermarket radio:
• Connect both the Black and Black/White wires to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the
Blue
wire to the amp turn on wire. This wire must be connected to hear sound
from the factory amplifier.
The following (1) wire is for a multimedia/navigation radio that requires this wire. If not
required, tape it off and disregard it.
• Connect the Blue/Pink wire to the speed sense wire (V.S.S.), if applicable.
• Connect the White RCA jack to the left front RCA output.
• Connect the
Gray
RCA jack to the right front RCA output
• Connect the
Green
RCA jack to the left rear RCA output.
• Connect the Purple RCA jack to the right rear RCA output.
Note: It is highly recommended that the radio being used has (2) sets of RCA outputs to
retain balance and fade; (3) sets if a subwoofer amplifier will be added .
• Tape off and disregard the following (8) wires, they will not be used in this application:
Green
,
Green/Black
,
Purple
,
Purple/Black
,
White
,
White/Black
,
Gray
, and
Gray/Black
.
Continue to 3.5mm jack steering wheel control retention