5
REV. 7/2/2018 INSTAX-ADGM03
CONNECTIONS TO BE MADE
(CONT.)
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the
Blue/Pink
wire to the VSS/speed sense wire.
Note:
There are (2) VSS/speed sense wires. If the
Blue/Pink
wire on the AX-GMCL2-SWC
harness is populated on the factory side, use that wire instead.
• Connect the
Green/Purple
wire to the reverse wire.
• Connect the
Light Green
wire to the parking brake wire
• Tape off and disregard the following (4) wires, they will not be used in this application:
Green
,
Green/Black
,
Purple
,
Purple/Black
From the AX-ADGM03 harness to the aftermarket radio:
• Connect the
Black
wire to the ground wire.
• Connect the
Yellow
wire to the battery wire.
• If installing either an ASWC-1 or AX-LCD (both sold separately), connect the (2)
Red
wires to
accessory power.
• Connect the
Green
wire to the left rear positive speaker output.
• Connect the
Green/Black
wire to the left rear negative speaker output.
• Connect the
Purple
wire to the right rear positive speaker output.
• Connect the
Purple/Black
wire to the right rear negative speaker output.
• Disconnect the (2) 4-pin Molex connectors, then attach the 4-pin to 4-pin resistor pad
harness.
• The
Black/Yellow
wire is used for OnStar level adjustment for models that do not come
equipped with steering wheel controls. Refer to the OnStar level Adjustment section for
further instructions.
The following (1) wire is only for a multimedia/navigation radio that requires this wire.
• If the
Blue/Pink
wire is populated on the factory side, connect this wire to the VSS/speed
sense wire.
• Connect the
Red
and
White
RCA jacks to the audio AUX-IN jacks from the aftermarket radio.
Continue to 12-pin pre-wired ASWC-1 harness
