4
CONNECTIONS TO BE MADE
(CONT.)
• Ensure the (2) 4-pin Molex connectors are connected together.
Note:
The 4-pin to 4-pin resistor pad harness will not be used in this application.
• The
Black/Yellow
wire is used for OnStar level adjustment for models that do not come
equipped with steering wheel controls. Refer to the OnStar level Adjustment section for
further instructions.
The following (1) wire is only for a multimedia/navigation radio that requires this wire.
• If the
Blue/Pink
wire is populated on the factory side, connect this wire to the VSS/speed
sense wire.
• Connect the
Red
and
White
RCA jacks to the audio AUX-IN jacks from the aftermarket radio.
Continue to 12-pin pre-wired ASWC-1 harness
Attention!
This interface will work with models that are either non-amplified, analog amplified,
or digital amplified. Please follow the instructions carefully for your model vehicle. Failure to
do so will result in either no sound, or low sound. If you are unsure if your vehicle is factory
amplified or not, please contact your local dealership.
For models
with
an analog amplifier:
From the 16-pin harness with stripped leads to the aftermarket radio (harness included with interface):
• Connect the
Red
wire to the accessory wire.
Note:
If installing either an ASWC-1 or AX-LCD (both sold separately), connect the (2)
Red
wires on the AX-ADGM03 harness as well.
• Connect the
Blue/White
wire to the amplifier turn on wire. This wire must be connected to
hear sound from the factory amplifier.
• If the aftermarket radio has an illumination wire, connect the
Orange/White
wire to it.
• If the aftermarket radio has a mute wire, connect the
Brown
wire to it. If the mute wire is
not connected, the radio will turn off when OnStar is activated.
• Connect the
Gray
wire to the right front positive speaker output.
• Connect the
Gray/Black
wire to the right front negative speaker output.
• Connect the
White
wire to the left front positive speaker output.
• Connect the
White/Black
wire to the left front negative speaker output.
Continued on the next page
