3
REV. 6/26/2018 INSTAX-ADFD01
CONNECTIONS TO BE MADE
(CONT.)
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the
Blue/Pink
wire to the VSS/speed sense wire.
• Connect the
Green/Purple
wire to the reverse wire.
• Connect the
Light Green
wire to the parking brake wire
• Tape off and disregard the following (4) wires, they will not be used in this application:
Green
,
Green/Black
,
Purple
,
Purple/Black
From the AX-ADFD01 harness to the aftermarket radio:
• Connect the
Black
wire to the ground wire.
• Connect the
Yellow
wire to the battery wire.
• If installing either an ASWC-1 or AX-LCD (both sold separately), connect the (2)
Red
wires
to accessory power.
• Connect the
Blue
wire to the power antenna wire.
• Tape off and disregard the
Blue/White
wire with a red connector, it will not be used in
this application.
• Connect the
Green
wire to the left rear positive speaker output.
• Connect the
Green/Black
wire to the left rear negative speaker output.
• Connect the
Purple
wire to the right rear positive speaker output.
• Connect the
Purple/Black
wire to the right rear negative output.
• If the vehicle is equipped with satellite radio or SYNC, and desired to be retained, connect
the
Red
and
White
RCA jacks labeled “RSE/SYNC/SAT” to the audio AUX-IN jacks.
Note:
Most Ford radios have satellite radio built into the radio, so this feature is lost if so.
• If the vehicle is equipped without SYNC, and the AUX-IN jack is desired to be retained,
connect the
Red
and
White
RCA jacks labeled “FROM 3.5” to the audio AUX-IN jacks.
• If the vehicle is equipped with a factory subwoofer, connect the
White
RCA jack labeled
“SUBWOOFER” to the subwoofer out jack.
• Disregard the
Red
RCA jack labeled “CENTER CHANNEL”, it will not be used in this application.
12-pin pre-wired ASWC-1 harness:
This harness is to be used along with the optional ASWC-1 (sold separately) to retain steering
wheel audio controls. If the ASWC-1 is not being used, disregard this harness. If the ASWC-1
will be used, please refer to the ASWC-1 instructions for radio connections and programming.
Disregard the harness that comes with the ASWC-1.
DIN jack:
The DIN jack is to be used with the optional AX-LCD (sold separately) to retain satellite radio or
SYNC information.
Continue to Installing & Programming the AX-ADFD01
