Aftermarket Radio Connection
If you are using an Eclipse or Kenwood radio
, plug the female 3.5mm
connector with the Brown and Brown/White wires into the male 3.5mm connector of the
ASWC-1 harness.
*
For Kenwood radios or JVC’s with the Blue yellow wire
: Connect the
Kenwood/JVC SWC wire (normally Blue/Yellow) to the Brown wire of the ASWC-1.
Isolate and tape the Brown/White wire, it will not be used.
**Some of the newer Kenwood radios will auto-detect as a JVC. If this is the
case, you can use a 12k ohm resistor (included) in line between the Blue/Yellow and
brown wire of the female 3.5mm jack during programming. Or you can manually
set the radio type which is in ASWC-1 manual.
*
For Eclipse radios
: Connect the Eclipse SWC wires (Normally Brown and
Brown/Black) to the Brown and Brown/White wires of the ASWC-1. Brown goes to
Brown and Brown/White goes to Brown/Black.
*
For Parrot Asteroid Smart or Tablet: Connect the ASWC-1 male 3.5mm
jack into the AX-SWC-PARROT (sold separately) female 3.5mm jack and plug the
4 pin end into the corresponding SWC plug on the radio.
* For XITE radios:
Connect the steering wheel control SWC-2 wire to the
BROWN
wire of the ASWC-1. Isolate and tape up the
Brown/White
wire, it will not be
used.
For all other radios
, plug in the male 3.5mm connector of the ASWC-1 into the back
of the aftermarket radio, designated for an external SWC control interface. Please refer to
the aftermarket radios manual if you are in doubt where the 3.5mm connector of the
ASWC-1 goes.
Once all connections have been made, plug in the aftermarket radio if not done already.
* If this is the first time the ASWC-1 is being installed:
