Axxera ASBT504, Руководство пользователя, Страница: 3 / 16

Power Wire (+12V)
Ground Wire (GND)
Remote Turn-on Wire (REM)
Input Signal
CAUTION
3
INSTALLATION
Connection Descriptions
s
Disconnect negative battery terminal before processing. Consult a qualified technician
for instructions if you are unsure.
s
Plan wire routing before cutting any wires to length. Begin by routing the power
+12V wire from the battery to the Smart EQ location.
Power line for amplifier can be shared. Use a grommet when running wires through
the firewall or metal openings. Avoid running the power wire near existing vehicle
wiring to prevent induced noise from entering the audio system.
s
Use extreme caution when drilling holes to avoid damaging fuel lines or existing
vehicle wiring.
s
Choose a clean unpainted section of metal or the vehicle chassis when attaching the
ground connection. Be sure to clean the area of any dirt or grease.
The Smart EQ ground wire can be shared to the ground line of the amplifier.
ACC Wire (+12V)
s!##WIREHASTOBECONNECTEDTOTHEACCESSORYWIREOFTHECAR
s
The remote turn-on wire can be connected to the remote turn-on terminal on the
amplifier. This is used to turn on the Smart EQ with a signal is detected.
s The Smart EQ’s input signal connects to the head unit’s low level(RCA) or high level
(speaker wire) outputs.
s
Low level input signals deliver the best performance.
If unavailable, use the high level inputs – when interfacing with factory head unit
Smart EQ’s output signals(RCA) connect to the amplifier’s low level inputs(RCA).
s
Do not use both low and high level inputs at the same time. Connect only one or
the other.
s
Keep low level inputs away from any power wires to avoid engine noise.
s
Never run any wires underneath or outside the vehicle.