AXTON A2100X, Руководство по установке

Страница: 24 / 46

24
E
COnnECTing
imPOrTAnT: DiSCOnnECT THE nEgATiVE mAin POWEr
CABlE FrOm yOUr CAr BATTEry BEFOrE Any
COnnECTiOn WOrk iS CArriED OUT!
recommended Power Cable Cross-Sections and main
Fuse Values (for +12V and ground cable based on
5 m +12 V cable)
model Cross-Section main Fuse
A2100X 10-16 mm² up to 60 A
A4050X 10-16 mm² up to 60 A
it is recommended to connect your amplifier according to
the following sequence:
1
Make sure your head-unit is turned off and the volume
control is in its minimum position.
2
RCA outputs of your head-unit to respective RCA
inputs of your amplifier. Sub pre-outs from head-unit
should be fullrange signals because lowpass pre-out sig-
nals always affect the filtering electronics of amplifier! In
case of doubt just 'double' a fullrange front or rear pre-out
by using Y-adaptors.
3
Next step: Connect the remote lead connection from
the head-unit to the amplifier.
4
Speaker cables to respective speakers or passive
crossovers. Make sure to maintain polarity! "+" to "+"
and "-" to "-".
For Mono 1-channel mode use of 4/2-channel models,
connect the two terminals "+" and "-" marked with
BRIDGE!
Min. impedance for bridged mode is 4 ohms!
5
Ground connection to chassis ground or negative battery
pole. If possible keep ground cable as short as possible
and make sure the chassis contact is well sanded, i.e. clean
from any paint, rust or dirt for lowest contact resistance.
6
+12 V power connection to positive battery pole. Do
not forget to install a main fuse within 20–30 cm of
car battery (fire hazard)!!!
Turn-on your head-unit keeping your volume at the lowest
setting. The green status LED on front of the amplifier heat
sink should light up now. If not, turn-off your head-unit
and re-check all wiring to and from the amplifier for miss-
ing or faulty connections.