VIA CABLE LOOM (STANDARD RECEIVER, PWM SIGNALS)
Connect each cable of the cable loom to the appropriate channel on the receiver, accor-
ding to the diagram.
Example:
Yellow cable Rx port for tail servo
Connect servos to ports 1-5. Throttle/ESC stays with the Rx. Leave unused channels
unplugged.
Note:
Single-line cables must be plugged into „signal pulse“.
VIA SERIAL INPUT (SEE SOFTWARE FOR OPTIONS)
If the receiver features a serial output, it can be connected via this port, so only one patch cable is
needed. Setting the designated signal type is done via software. In this case, the throttle channel
is looped through by the system, its output supplied at port 6, according to the diagram.
A further channel is available on port A (AUX, e.g. for illumination accessories or retractable gear).
VIA SATELLITE RECEIVERS (SPEKTRUM)
Up to 2 (diversity) receivers can be connected on the side of the system. If only one satellite is used
(technically possible, but not recommended), the port closer to the LED is to be used (Master).
Setting this input type, as well as binding the receivers to the radio, is carried out via the software.
No main receiver is needed to bind or use the satellites directly on the device.
The usual input ports (when using the cable loom) for tail gyro and head gyro as well as horizon
channel must be idle, i.e. not connected to any signal source (see diagram for cable loom con-
nection).
When using Spektrum satellites, the system needs to be supplied with a min. 5,5V. 4,8V batteries
are not sufficient, the receivers may fail under load or not bind at all. We recommend a voltage
controlled output to supply the system, such as a BEC, with a capable LiPo or LiFe pack.
CONNECTION NOTES
As high servo currents can occur, a voltage supply should be routed directly to the device, this
is also the case with a master-slave supply (BEC with 2 or more supply cables, all routed to the
device). In this way the receiver will be supplied via the system, and not vice versa.
When using the supplied cable loom and an ESC’s internal BEC, which must be connected to the
receiver’s throttle output, the power supply via the cable loom is sufficient. In this case any slave
supply should be routed to the receiver, not split between receiver and device.
Use one of the following options to supply power directly to the unit:
a) All output ports 1-6
b) Ports A and B, if a serial input is used
In both cases, and if the number of available ports is not enough, make use of a Y cable to achieve
the power source connection.
CONNECTION
ANSCHLUSS KABELB
AUM
Roll/Ail
Nick/Elev
Pitch
Heck/Rud
Kopf-/Head Gyro
Horizont
Heck-/T
ail Gyro
1
2
3
6
5
4
Servo 1
Servo 2
Servo 3
Servo 4
Heck/Rud
Gas/Thr/ESC
SER
VO
RX
1
2
3
6
5
4
Servo 1
Servo 2
Servo 3
Servo 4
Heck/Rud
Gas/Thr/ESC
SER
VO
RX
ANSCHL
USS SUMME-IN/SUMME-
OUT
5
Slave
Master
