Axnes AS
Document number
Revision
Date
Page 2-17
VOX Maximum Level:
When the VOX trigger level increases because of ambient noise, the
trigger level can never pass the VOX maximum level, even if the ambient noise indicates that
a higher trigger level should have been used. The setting is persistent over a power cycle.
VOX Minimum Level:
The equipment is by default set to minimum VOX level when VOX
mode is entered. The VOX trigger level will increase as the environmental audio conditions
force the level up. The setting is persistent over a power off-on cycle.
Display Intensity:
Display illumination intensity can be regulated in steps between 1-9. The
setting is persistent over a power off-on cycle. At start up the programmed default intensity is
used, and then gradual adapting to the user selected intensity over a few seconds.
GPS Enable:
Enable/disable GPS position polling. Minimum rate for position update to base
station is affected by the amount of active GPS reporters. Few active GPS reporters will
shorten the time between position reports. The setting is persistent over a power off-on cycle.
Software Version:
Select what to show with the configuration up and down buttons. The
following information can be displayed:
•
Main SW version
•
Crypto Key Name
•
Battery Gauge parameter version
•
CRC of the configuration (can be used to identify the configuration)
•
Capabilities programmed
•
Programmed serial number (Shall match S/N on the Label)
•
Boot SW version
•
SW hash of main SW.
Parameter Reset:
Reset the parameters that can be modified from the Menu back to factory
default values. (Squelch, Audio Feedback, Headset type, VOX max. level, VOX min. level,
Display intensity, Bluetooth). To reset the parameters:
•
Enter the Parameter Reset menu
•
Change from Return to Confirm with the configuration up or down arrow
•
Push OK
Audio feedback
The MP30 implements audio feedback on events that are of importance to the operator. The
following spoken feedbacks are given:
Connected
– Connection established to PNG Base Station
Connection lost
– Connection to PNG Base Station lost
Locked
– Key lock enabled
Unlock
– Key lock unlocked
