Axminster UJK Technology 502701, Инструкция по эксплуатации, Страница: 11 / 16

Fitting the Router and the Cutters
Setup/Operating Instructions
11
NOTE. If you find that some of your cutters are ‘borderline’
for ‘reach’ or the length of shank remaining in the collet is
approaching the minimum limit, may we suggest the
purchase of the short collet extension Axminster No.
211367. (See Page 4)
NOTE. If you are not using a professional router table
with a remote On/Off switching facility, or a Power Tool
NVR Switch (similar to Axminster 910065) remember
to orientate the router so that the power switch is easily
accessible when the router elevator is fitted to the work
platform.
When everything is assembled to your satisfaction. Check
the speed setting of the router is correct for the cutter
diameter. Give the router a ‘quick burst’ to check that
everything is secure. If the ‘quick burst’ check is O.K.
Proceed to fit your fencing, dust extraction etc
Ensure you have identified all the parts of your
Router Elevator.
Place the Router Elevator into the prepared recess. (See Fig
A on page 05). Check that it is flush with the work platform
surface. If this is not the case insert the supplied grub
screws in the threaded corner holes and level the machine
table. (See Fig 4) If, for some reason, it is impossible to level
the table absolutely flush with the work platform, ensure
that the ‘front’ of the table is low in the recess, and the ‘rear’
of the table is high to the work surface. (Low and High in
this instance refer to the minimal measurements required
to ensure that there is no ‘edge’ for the work piece to ‘snag’
on). When you are satisfied with the levelling process you
can, if required, fasten the elevator in position with the two
M6 bolts supplied or even two Wood Screws. (perhaps an
MDF working platform/table?).
Straight edge
Grub screw
Fig 4