Axminster AWEBDS46 MkII, Руководство пользователя

Страница: 21 / 28

21
Vertical Sanding
If you require to raise the linishing table to the vertical using the 6mm Allen Key provided loosen
the swivel mandrel caphead bolt (See fig 11). Raise the linisher table either to its vertical stops or
to the position required & re-tighten the swivel mandrel-clamping bolt.
Once the linisher is in the vertical position the work stop plate can be used to support small
pieces while sanding.
The sanding disc table can be mounted in place of the workstop plate to give more support and
the use of the mitre fence.
Remove the work stop plate from the linisher chassis and place safely aside.
Undo the star threaded bolt and remove the table.
Line up the table to the embossed hole in the linisher chassis then introduce the star knob
threaded bolt through the slot in the clamping quadrant and screw into the threaded hole in the
linisher chassis. (See fig 25) Use a known 90° reference (square?) and check that the table is set
square to the belt sander.
Introduce the table spigot into the hole in
the linisher chassis.
introduce the star knob threaded bolt
through the slot in the clamping quadrant
and screw into the threaded hole in the
linisher chassis.
The disc table mounted
to the linisher
Fig 25
Raising the linisher to vertical
Mounting the disc table to the Linisher