Axminster AH-1218, Руководство пользователя

Страница: 14 / 20

Removing Drive/Live Centres
14
To remove the Drive Centre (F), locate the push rod (H), while holding the Drive Centre insert the push rod (H)
through the centre hole of the headstock wheel and push the Drive Centre (F) out (see fig 31).
Repeat the procedure for the Live Centre (G) in the tailstock (see fig 32).
Fig 31 Fig 32
H H
G
F
Maintenance
Daily after use Monthly
• Clean wood shavings away from the lathe bed and
tool rest.
• Spray a light coat of Camellia Oil or Axcaliber Dry
Lubricant, (see our cataloge for details) over the lathe
bed, to allow the Banjo and Tailstock to run more
smoothly over the bed, also spray the headstock and
tailstock to prevent corrosion. •Check the tension of the belt and adjust if required,
(See Changing the Belt Speed). Also check the
condition of the belt for signs of wear and change
if required, (contact our technical department on
03332 406406)
•Check any build up of wood shaving on the motor
and spindle pulleys and clean if necessary.
• Using an airline, blow out the motor’s air vent.
• Also blow out the air vents on top of the control
box for the variable speed lathe (AH-1218VS).
Note: If the lathe is not going to be
used for a period of time, spray a light
coat of oil over the bed and place a
dust sheet over the lathe.