8
If you find the reading has increased there could be a
blockage in the ducting system or extractor unit, check
the following:
• Check the rear filter for signs of build of sawdust and
clean with a vacuum cleaner
• Check the shaker motor is working properly
• Check the hoses for blockages
• Check the bin bag and empty if full
If the reading has decreased, check the following:
• Check the hoses are secure, ‘NOT LOOSE’ which will
lead to air leakages
• Check hoses for splits and cracks
• Check “Blastgates” that are not in use are shut
OPERATING AND ADJUSTMENTS
WARNING!! BEFORE CARRYING OUT ANY
MAINTENANCE DISCONNECT THE CYCLONE
EXTRACTOR FROM THE MAINS SUPPLY
ALWAYS TURN ON/OFF THE EXTRACTOR BY THE
NVR CONTROL SWITCH NOT THE MAINS SWITCH
This is to allow the shaker motor on the (AP357CEH)
to perform the self cleaning operation. If the cyclone
extractor is turned off at the mains switch, the shaker
motor will not cut in. If this is constantly repeated,
eventually the filter will become blocked, causing
reduced performance.
Switching ON/Off
THE REMOTE CONTROL
The manometer is used to monitor the air flow in the
ducting system. When you first use your extractor it is
recommended you mark on ‘manometer’ the pressure
the extractor it running at, to do this follow the
instructions below.
Note: the reading can vary depending on the size of
the ducting system.
1. Connect your cyclone extractor to the ducting system.
Figure 01
2. Start up the extractor by pressing the ‘green’ button on
the NVR switch assembly and check the reading on the
manometer.
3. Using a marker or sticky label mark the reading on the
manometer, (see figure 01). This is to confirm that every
time you switch on you know what the read will be.
For all of our accessories please see our catalogue and
website or contact us on:
Freephone: 03332 406 406
Extraction Accessories
Replacement Waste Sacks
Code: 106369 Bin Sacks for AP154CEH & AP176CEH
Code: 106370 Bin Sacks for AP357CEH
Code: 106368 Filter Sacks for AP154CEH, AP176CEH, AP357CEH
1. Green button turns ON the
extractor
2. Red button turns OFF the extractor
3. NOTE: C & D buttons are
disconnected and no longer in use.
Requires a 12V, type A27 battery.
Note: The remote control operates on
radio frequency and has a 60-ft. range.
It does not need to be aimed at the
control box tooperate.
