Axminster Trade AT430DS, Оригинальное руководство пользователя, Страница: 17 / 42

16
Inventory
The following is a description of the main components shipped with your machine. Lay the
components out to inventory them.
Note:
If you can't find an item on this list, check the mounting location on the machine or
examine the packaging materials carefully. Occasionally we pre-install certain components
for shipping purposes.
A. Drum Sander (not shown)............................................. 1pc
B. Handle……………………………………………………..…1pc
C. Crank Handle.................................................................. 1pc
D. Dust Port 4"..................................................................... 1pc (DS17….2pcs)
E. Hex Wrench 3mm (not shown)....................................... 1pc
F. Level plates (not shown)................................................. 2pcs
CRANK HANDLE
Now the crank handle that came with the machine
needs to be installed. The handle should be installed
on the top left side of the unit. Make sure that the
set screws and handle are firmly in place before
moving on.
DUST COLLECTION
It is highly recommended that you use a dust
collector when using this machine. The minimum
CFM requirement for this machine is 750CFM
which means you should be using a 1HP or 2HP
dust collector at minimum.
The machine comes with a 4” dust port located
at the top of the machine.
You can use a dust collection adaptor which will
take you up to 4” in order to use a normal sized dust collector. A fine layer of dust will