Axminster Trade 501210, Оригинальное руководство пользователя

Страница: 11 / 20

Changing the Sanding Disc
11
DISCONNECT THE SANDER FROM
THE MAINS SUPPLY BEFORE
CONTINUING!
RECONNECT THE SANDER TO THE
MAINS SUPPLY AND CONTINUE
WITH OPERATION.
Fig 16
clean dry cloth. Locate the sanding disc, peel the cover from
the adhesive surface and apply CAREFULLY to the disc (see
fig 16). Use a piece of cloth in your hand or wear a glove, to
firmly press the abrasive to the disc, the application will be
reinforced by a gentle sanding action across the face when
you first use the new sanding disc.
Step 7 Re-assemble the sander as described opposite but in
reverse (see figs 10 to 14).
Maintenance
There is very little mechanical maintenance that can be
carried out on the machine. Most prudent maintenance
is preventative and concerned with keeping the machine
clean.
1. At reasonable intervals, inspect and remove all dust/resin
build ups, and blow the motor clean.
2. Remove the table assembly and lower the extraction
housing, clean any dust or resin build up. Re-assemble the
sander.
3. Inspect the sanding disc for signs of wear and tear and
replace if necessarily.
4. From time to time using a damp cloth wipe over the
sanders surface.
Troubleshooting
TROUBLE PROBABLE CAUSE REMEDY
Motor does not run when power
switch is pressed “ON” 1. Switch is burnt out
2. Connection wire is loose or
damaged 1. Replace the switch
2. Tighten wire or replace
Motor does not run at full speed 1. Power voltage is too low
2. Motor is damaged. 1. Test voltage
2. Check and repair motor
Motor does not reach full power
1. Incorrect power wiring
2. Overloaded 1. Replace with the correct size of
power wiring
2. Reduce load
Motor overheating 1. Motor voltage is different
2. Motor is damaged 1. Check the voltage label
2. Check and repair the motor
Turn the disc while applying pressure
Remove the rear guard and blow the motor clean
Remove the three
Phillips screws
Motor rear guard