Axminster Trade 107644, Руководство пользователя

Страница: 5 / 36

ASSEMBLY
5
Floor Mounting Feet
Cast Iron Table
Table Support Gas Strut
Remove the shipping pallet and place aside. Locate the four
mounting feet (E) and with help mount them to each corner of
the bandsaws base, see fig 01.
Manoeuvre the bandsaw to the required position with plenty
of space around the unit. Adjust each foot in turn until the
bandsaw is level.
Remove the two clamping handles (A) from the underside
of the table. Lower the table down so the steel threaded slot
through the two holes on either side of the tilt quadrant and
the trunnion (B) rests in the quadrants cradial. Replace the two
clamping knobs (A) to secure the assembly, see fig 02.
Fig 01
Fig 02
Tilt quadrant
Continues over...
1
2
1. Locate the two gas strut brackets, secure the first bracket
using two Hex screws, washers/spring washers to the underside
of the table. Repeat for the remaing bracket to the rear of the
bandsaw, see picture 1.
2. Locate the gas strut, the two pins and split pins. Lineup the
mounting hole in the gas strut housing with the pre-drilled
hole in the bracket, insert the pin through. Slot the split pin
through the pin’s hole and bend the split pin back to secure
the strut in place, see picture 2. Repeat the process for the
lower end of the gas strut, see picture 3 on page 6.
Split pin
Pin
Gas strut housing
Gas strut
support bracket