Axminster Craft AC456SS, Инструкция по эксплуатации

Страница: 22 / 28

Maintenance
22
Fig 38
Remove the
motor brush
2. Carefully remove the motor brush, see fig 38. Check the brush
for signs of wear. If it’s O.K. re-fit. If the brush has worn down to
a third of its length replace with a new one.
3. Turn the scroll saw on its side allowing access to the other
brush access port, see fig 39-40.
Fig 39-40
Motor access port
General Maintenance
The motor is permanently lubricated. Do not try to oil the motor
bearings or service any internal parts of the motor. If the power
cord is worn, frayed, cut or damaged, contact Axminster Tools
& Machinery. Do not try to patch it up with electrical tape, this
could lead to more trouble.
WARNING! WEAR A DUST MASK
AND EYE PROTECTION.
Cleaning
1. Remove the scroll saw’s side access panel and table insert
plate. Using an ‘M’ class Vacuum Cleaner, clean the accumulated
dust from inside the lower housing that included the motor
assembly, rocker arm, lower and upper blade holders, table
and the table insert void, see fig 41-42.
Fig 41-42
2. If you have finished using the scroll saw, clean above and
below the work table and wipe the scroll saw over, see fig 41-42.
3. If the scroll saw is not going to be used for
a period of time, use ‘Ambersil Dry PTFE Film
Antistick’, spray, code 952137 over the work
table to prevent the table from rusting and
place a dust sheet over the scroll saw.