AXIS Q60–E Network Dome Camera Series
How to repaint the product
How to repaint the product
Preparations
•
If applicable, disassemble the equipment according to the instructions in this document.
•
Remove gaskets, screws, electrical components, connectors and plugs, windows, and domes from the parts to be repainted.
•
Clean all parts to be repainted thoroughly to remove grease, dust, or oil.
•
To ensure reassembly and functionality of the product, mask openings for screws, LED indicators, or microphones before
painting.
Pretreatment of parts
Depending on the part material and type of paint applied at factory, different pretreatment should be done for the new paint to
adhere as well as possible. Clean the parts properly to remove oil, grease and dust.
For more information on the materials used in the product, see its datasheet at
www.axis.com
Powder coated parts -
Using fine sandpaper, remove the original powder coating down to the base material and clean the parts
before painting, or use a primer.
Anodised and chromated parts -
Use a primer.
Uncoated stainless steel -
No special pretreatment is needed, but make sure that the surface is clean before painting.
Plastic -
Use a primer.
3
