AXIS Q1659 Network Camera
Connectors
Network connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
NO
NO
NOTICE
TICE
TICE
The product shall be connected using a shielded network cable (STP) or an optical fiber
cable. All cables connecting the product to the network shall be intended for their
specific use. Make sure that the network devices are installed in accordance with
the manufacturer’s instructions. For information about regulatory requirements, see
Electromagnetic compatibility (EMC) on page 2
.
I/O connector
Use with external devices in combination with, for example, tampering alarms, motion detection,
event triggering, and alarm notifications. In addition to the 0 V DC reference point and power (DC
output), the I/O connector provides the interface to:
•
Digital output
– For connecting external devices such as relays and LEDs. Connected
devices can be activated by the VAPIX® Application Programming Interface, output
buttons on the Live View page or by an Action Rule. The output will show as active
(shown under
System Options > Ports & Devices
) if the alarm device is activated.
•
Digital input
– For connecting devices that can toggle between an open and closed
circuit, for example: PIRs, door/window contacts, glass break detectors, etc. When a
signal is received the state changes and the input becomes active (shown under
System
Options > Ports & Devices
).
4–pin terminal block
Audio connector
The Axis product has the following audio connectors:
•
Audio in (pink)
– 3.5 mm input for a mono microphone, or a line-in mono signal.
•
Audio out (green)
– 3.5 mm output for audio (line level) that can be connected to
a public address (PA) system or an active speaker with a built-in amplifier. A stereo
connector must be used for audio out.
14
