AXIS P14-LE Bullet Camera Series
Configure your device
Set the PIR detector to an input port
1. Go to
System > Accessories > I/O ports
.
2. Set the direction to
Input
for port 1.
3. Give the input module a descriptive name, for example “PIR detector”.
4. To trigger an event whenever the PIR detector senses motion, set the normal state to
Circuit open
.
Set the switch relay to an output port
1. Set the direction to
Output
for port 2.
2. Give the output module a descriptive name, for example “Gate switch”.
3. To open the gate whenever an event is triggered, set the normal state to
Circuit closed
.
Create rules
For the camera to open the gate when the PIR detector senses someone nearby, you need to create a rule in the camera:
1. Go to
System > Events
and add a rule.
2. Type a name for the rule, for example “Open gate”.
3. In the list of conditions, select
PIR detector
.
4. In the list of actions, select
Toggle I/O once
.
5. In the list of ports, select
Gate switch
.
6. Set state to
Active
.
7. Set the duration.
8. Click
Save
.
9. Create another rule with the name “Direct the camera to the gate".
10. Select the same input signal as before, but as action select the previously created “Gate entrance” preset position.
11. Click
Save
.
Record video when the camera detects loud noises
This example explains how to set up the camera to start recording to the SD card five seconds before it detects loud noise and
to stop two minutes after.
Note
The following instructions require that a microphone is connected to audio-in.
Turn on audio:
1. Set up the stream profile to include audio, see
Add audio to your recording on page 18
.
Turn on audio detection:
1. Go to
System > Detectors > Audio detection
.
2. Adjust the sound level according to your needs.
Create a rule:
16
