AXIS P1367-E Network Camera
Specifications
•
Enabling the Focus Assistant. Press and very quickly release the Control button.
•
Resetting the product to factory default settings. See
How to reset to factory default settings on page 15
.
•
Connecting to an AXIS Video Hosting System service. To connect, press and hold the button for about 3 seconds until the
status LED flashes green.
Connectors
Network connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
Audio connector
The Axis product has the following audio connectors:
•
Audio in (pink)
– 3.5 mm input for a mono microphone, or a line-in mono signal.
•
Audio out (green)
– 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an
active speaker with a built-in amplifier. It is recommended to use a stereo connector for audio out.
For audio in, the left channel is used from a stereo signal.
3.5 mm audio connectors
(stereo)
1 Tip
2 Ring
3 Sleeve
Audio Input
Microphone/Line in
Microphone bias voltage
Ground
Audio Output
Line out, mono
Line out, mono
Ground
I/O connectors
Use the I/O connector with external devices in combination with, for example, tampering alarms, motion detection, event triggering,
and alarm notifications. In addition to the 0 V DC reference point and power (DC output), the I/O connector provides the interface to:
Digital output -
For connecting external devices such as relays and LEDs. Connected devices can be activated by the VAPIX®
Application Programming Interface or in the product’s webpage.
Digital input -
For connecting devices that can toggle between an open and closed circuit, for example PIR sensors, door/window
contacts, and glass break detectors.
4-pin terminal block
RS485/RS422 connector
Two 2-pin terminal blocks for RS485/RS422 serial interface used to control auxiliary equipment such as pan-tilt devices.
19
