Axis P1347-E, Руководство пользователя

Страница: 48 / 61

AXIS P1347–E Network Camera
System Options
The following traps are available:
• Cold start
• Warm start
• Link up
• Authentication failed
SNMP v3
provides encryption and secure passwords. To use traps with SNMP v3, an SNMP v3 management application is required.
To use SNMP v3, HTTPS must be enabled, see HTTPS, on page 42 . To enable SNMP v3, check the box and provide the initial user
password.
Note
The initial password can only be set once. If the password is lost, the Axis product must be reset to factory default, see
Reset to factory default settings, on page 51 .
UPnP TM
The Axis product includes support for UPnP TM . UPnP TM is enabled by default and the product is automatically detected by operating
systems and clients that support this protocol.
UPnP
TM
can be disabled under
System Options > Network > UPnP TM
.
RTP/H.264
The RTP port range and multicast settings are con fi gured under
System Options > Network > RTP
.
The RTP port range de fi nes the range of ports from which the video/audio ports are automatically selected. For multicast streams,
only certain IP addresses and port numbers should be used.
Select Always Multicast Video and/or Always Multicast Audio to start multicast streaming without opening an RTSP session.
Bonjour
The Axis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by operating
systems and clients that support this protocol.
Bonjour can be disabled under
System Options > Network > Bonjour
.
Storage
SD card
The SD card is managed on the System Options > Storage page. Click SD card to open Storage Management .
Mounting is done automatically when the card is inserted or when the product boots. SD cards are normally preformatted when
purchased, but if needed, click Format to format the card.
Format an SD card so that it can be written to one of two available options — VFAT and ext4. During the formatting any previous
data stored on the disk will be lost. The recommended format is ext4, due to its resilience against data loss if the card is ejected
or if there is abrupt power loss. A third-party ext4 driver or application is also needed to access the fi le system from Windows.
Note that most SD cards are pre-formatted with vFAT when purchased. The
Check Disk
option is used to check for errors on the SD
card and only works for the fi le system ext4. The
Repair
option repairs the SD card of errors in the fi le system ext4. For vFAT fi le
system use a card reader or PC to perform card maintenance.
Note
To prevent corruption of recordings, the SD card should always be unmounted before removal.
48