AXIS P1245 Network Camera
About system options
AXIS Video MIB (Management Information Base) for video hardware can be used to monitor Axis-specific, hardware-related
issues that may need administrative attention. For more information about AXIS Video MIB and to download MIB files, go to
www.axis.com/support
To enable and configure SNMP in the Axis product, go to the
System Options > Network > SNMP
page.
Depending on the level of security required, select the version on SNMP to use.
Traps are used by the Axis product to send messages to a management system on important events and status changes. Check
Enable
traps
and enter the IP address where the trap message should be sent and the
Trap community
that should receive the message.
Note
If HTTPS is enabled, SNMP v1 and SNMP v2c should be disabled.
Traps for SNMP v1/v2
are used by the Axis product to send messages to a management system on important events and status
changes. Check
Enable traps
and enter the IP address where the trap message should be sent and the
Trap community
that
should receive the message.
The following traps are available:
•
Cold start
•
Warm start
•
Link up
•
Authentication failed
Note
All AXIS Video MIB traps are enabled when SNMP v1/v2c traps are enabled. It is not possible to turn on or off specific traps.
SNMP v3
provides encryption and secure passwords. To use traps with SNMP v3, an SNMP v3 management application is required.
To use SNMP v3, HTTPS must be enabled, see
. To enable SNMP v3, check the box and provide the initial user
password.
Note
The initial password can only be set once. If the password is lost, the Axis product must be reset to factory default, see
to reset to factory default settings on page 44
.
UPnP
The Axis product includes support for UPnP
®
. UPnP is enabled by default and the product is automatically detected by operating
systems and clients that support this protocol.
UPnP can be disabled under
System Options > Network > UPnP
.
RTP/H.264
The RTP port range and multicast settings are configured under
System Options > Network > RTP
.
The RTP port range defines the range of ports from which the video ports are automatically selected. For multicast streams, only
certain IP addresses and port numbers should be used.
Select
Always Multicast Video
to start multicast streaming without opening an RTSP session.
Bonjour
The Axis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by operating
systems and clients that support this protocol.
39
