Axis Dyno Moto VX-12, Руководство пользователя, Страница: 31 / 48

Labjack Replacement
Follow these steps:
1. Remove the 8 screws (4 on each end) from the faceplates of the electronics box.
2. Bend the faceplate containing the USB plug down as shown below.
3. Slide the top body of the box off the bottom plate and over the faceplate as shown
below.
4. Remove the USB, smoothing box, and power filter board from the Labjack. The
smoothing box and power filter board are held on with Velcro. See below.
5. Loosen all terminals on the Labjack and pull wires back out of terminal slots.
6. Remove Labjack from bottom plate. It is held to the bottom plate with Velcro.
7. Add mating Velcro strip to bottom of Labjack, then place Labjack in position on the
bottom plate.
8. Replace wires into the correct terminal slots, and tighten each. See image below for
wire positions. Note that all terminals marked “VS” are connected and all terminals
marked “GND” are connected and which of these slots are utilized may vary from box to
box.
9. Reassemble box following steps 1-4 in reverse order.
31