AXIS P33 Network Camera Series
Additional settings
•
Axis PIR detector
NO
NO
NOTICE
TICE
TICE
Disconnect the camera from power before connecting the wires. Reconnect to power after all connections are done.
Connect the wires to the camera’s I/O connector
Note
For information on the I/O connector, see
.
1. Connect the ground wire to pin 1 (GND/-).
2. Connect the power wire to pin 2 (12V DC output).
3. Connect the I/O wire to pin 3 (I/O input).
Connect the wires to the PIR detector’s I/O connector
1. Connect the other end of the ground wire to pin 1 (GND/-).
2. Connect the other end of the power wire to pin 2 (DC input/+).
3. Connect the other end of the I/O wire to pin 3 (I/O output).
Configure the I/O port in the camera’s webpage
1. Go to
Settings > System
>
I/O ports
.
2. Give the input module a descriptive name.
3. To make the PIR detector send a signal to the camera when it senses motion, select
Closed circuit
in the drop-down list.
To trigger the camera to start recording when it receives a signal from the PIR detector, you need to create a rule in the camera’s
webpage.
Detect tampering with input signal
This example explains how to trigger an alarm when the input signal has been cut or short-circuited. For more information about the
I/O connector, see
.
1. Go to
Settings > System > I/O Ports
and turn on
Supervised I/O
.
Create a rule:
1. Go to
Settings > System > Events
and add a rule.
2. Type a name for the rule.
3. In the list of conditions, select
Digital input
and then select a port.
4. In the list of actions, select
Send notification to email
and then select a recipient from the list. Go to
Recipients
to create a new recipient.
To create a new recipient, click
. To copy an existing recipient, click
.
5. Type a subject and a message for the email.
13
