AXIOMTEK NA590 Series, Руководство пользователя, Страница: 18 / 78

NA590 Series User
’s Manual
12 Hardware and Installation
2.3 Jumper Settings
Jumper is a small component consists of jumper clip and jumper pins. Install jumper clip on 2
jumper pins to close. And remove jumper clip from 2 jumper pins to open. Below illustration
shows how to set up jumper.
This section provides the information about jumpers and connectors of NA590 Series. Properly
configure jumper settings on the main board in this appliance to meet your application purpose.
Below we list a summary table of all jumpers and default settings for onboard devices.
Jumper Definition Jumper Setting
JP1 reserve
No Jumper
：
Normal (default)
JP3 Clear CMOS Setting
1-2
：
Normal (Default)
2-3
：
Clear CMOS
JP6
JP7
JP8
LAN Bypass Trigger When
Power On
(1-2)/(1-2)/(1-2)
：
Mother board/SEGN1 ~2 Bypass as same as Power Off status
(1-2)/(1-2)/(2-3)
：
Mother board/SEGN1~2 Bypass Disable(Default)
(1-2)/(2-3)/(2-3)
：
Mother board/SEGN1 ~2 Bypass Enable
JP9 Case Open Setting
1-2
：
case open
No Jumper
：
Normal (default)
JP10
TACT SW1 Selection
1-2
：
Power button On/Off
2-3
：
Reset (Default)
4-5
：
GPI
JP11 reserve No Jumper
：
Normal (default)
JP12
Auto Power Button Mode
Selection
1-2
：
Always Power Off
No Jumper
：
Always Power On (Default)