AXIOMTEK MANO860, Руководство пользователя

Страница: 34 / 88

MANO860 User’s Manual
30
BIOS Setup

ATX Power Button/Soft-off Button (Pin 6-8 PWRBT)
This 2-pin connector is for the system power button. Pressing the power button turns the system on or
puts the system in sleep or soft-off mode depending on the BIOS settings.
Pressing the power switch
and holding it for more than four seconds while the system is ON turns the system OFF.

Reset Button (Pin 5-7 SYS_RST)
This 2-pin connector is for the chassis-mounted reset button for system reboot without turning off the
system power.

Power LED (Pin 2-4 PWRLED)
This 2-pin connector is for the system power LED. Connect the chassis power LED cable to this connector.
The system power LED lights up when you turn on the system power, and blinks when the system is in
sleep mode.

Hard Disk Drive Activity LED (Pin 1-3 HDLED)
This 2-pin connector is for the HDD Activity LED. Connect the HDD Activity LED cable to this connector.
The IDE LED lights up or flashes when data is read from or written to the HDD.
1.8.4 ATX power connectors (EATXPWR1, ATX12V1)
The connector is for ATX power supply plugs. The power supply plugs are designed to fit these connectors in
only one orientation. Find the proper orientation and push down firmly until the connectors completely fit.
EATXPWR1
ATX12V1

Use of a PSU with a higher power output is recommended when configuring a
system with more power-consuming devices. The system may become
unstable or may not boot up if the power is inadequate.

Make sure that your power supply unit (PSU) can provide at least the minimum
power required by your system. See the table below for details.