Adjusting Measuring Reference
Press
(4) to switch reference point between the front and the rear of the instrument.
There is a beep warning tone when reference point is changed.
The default reference setting is from the rear of the instrument. The reference point will be set to default
every time when it’s powered off, i.e. the measuring reference point is from the rear of the instrument
every time when it’s powered on.
Measurement Unit
Long press
(7) to change distance unit between m, ft, in and ft+in.
6. Operating instructions
Single Distance Measurement
Press
(1) to activate the laser.
Press
(1) again to trigger the distance measurement. The measured value is displayed immediately.
Continuous Measurement (Min / Max)
Long press
(1) to activate continuous measurement. The maximum and minimum distances measured
are shown in the display.
The last measured value is displayed in the summary line. User can press (1) or (8) to stop the function.
*This function will be stopped automatically after 5 minutes of inactivity.
