Axiom SW212Al, Руководство пользователя

Страница: 9 / 16

9
PRONET AX OPERATION
PRONET AX software has been developed in collaboration with sound engineers and sound designers, in order to offer an “easy-to-
use” tool to setup and manage your audio system. With PRONET AX you can visualize signal levels, monitor internal status and edit
all the parameters of each connected device.
Download the PRONET AX app registering on MY AXIOM at the website at https://www.axiomproaudio.com/.
For the network connection the
USB2CAN-D
(with 2-port) converter optional accessory is needed.
PRONET AX network is based on a “bus-topology” connection, where the first device is connected to the network input connector
of the second device, the second device network output is connected to the network input connector of the third device, and so
on. To ensure a reliable communication the first and the last device of the “bus-topology” connection must be terminated. This can
be done by pressing the “TERMINATE” switch near the network connectors in the rear panel of the first and the last device. For
the network connections simple RJ45 cat.5 or cat.6 ethernet cables can be used (please don’t confuse a ethernet network with a
PRONET AX network these are completely different and must be fully separated also both use the same kind of cable).
Assign the ID number
To work properly in a PRONET AX network each connected device must have a unique identifier number, called ID. By default the
USB2CAN-D PC controller has ID=0 and there can be only one PC controller. Every other device connected must have its own unique
ID equal or greater than 1: in the network cannot exist two devices with the same ID.
In order to correctly assign a new available ID to each device for working properly in a Pronet AX network, follow these instructions:
1. Switch off all the devices.
2.
Connect them correctly to the network cables.
3. “TERMINATE” the end device in the network connection.
4.
Switch on the first device keep pressed “PRESET” button on the control panel.
5. Leaving the previous device switched on, repeat the previous operation on the next device, until the latest device is turned on.
The “Assign ID” procedure for a device makes the internal network controller to perform two operations: reset the current ID; search
the first free ID in the network, starting from ID=1. If no other devices are connected (and powered on), the controller assume ID=1,
that is the first free ID, otherwise it searches the next one left free.
USB2CAND
not
pressed
pressed
LAST DEVICE
network
network
FIRST DEVICE
AND FOLLOWING
notebook
with PRONET AX so�ware
USB 2.0 port
1) pressed if the USB2CAND is the first device
2) not pressed if more AXIOM systems are connected
to the second connector
EXAMPLE OF PRONET AX NETWORK WITH SW212A AND AX16CL