6
Explanations of Symbols
The voltage tester shows the following symbols:
Inserting/Changing the Batteries
The voltage tester is operated with two micro-batteries (type AAA, in the scope of delivery).
Proceed as follows to insert or change the batteries:
• Loosen the screw on the battery compartment lid (9) with a suitable screwdriver
and remove it.
• Insert two micro-batteries (AAA) into the battery compartment. Observe the
polarity information in the battery compartment. If possible, use alkaline
batteries.They guarantee a longer service life.
• Then, carefully close and screw down the battery compartment lid again.
The batteries need to be changed if the „Low Bat
“symbol lights up on the
LCD display or when the LCD display stays dark after contacting both test tips.
The voltage tester will show no reading if the batteries are flat. The device must not
be operated with flat batteries or without batteries.
DC
DC voltage
AC
AC voltage
DC voltage negative potential (DC)
Phase display from 100 to 690V ~ 50/60Hz
when used as a „single-pole“ phase tester.
Continuity test symbol
Rotating field display clockwise
Rotating field display anticlockwise
Device for work to be performed with voltage present
Battery replacement symbol
