Operation Instructions
SPL 1-00/-01
Chapter
3:
Powerline Network Security
10
© AXING AG • Reserving change in design and type - We cannot be held liable for printing errors
18.12.12
3.
Press the Security/Reset button at the left side of your powerline device for more
than 10 seconds until the PLC LED flashes. This resets the network name to a
random value and removes your device from any network it may belong to.
Power LED
PLC LED
Ethernet LED
4.
Press the Security/Reset button at the left side of your powerline device for 1
second. The PLC LED will blink as the powerline device tries to set up a
connection.
5.
Repeat step 4 in this section for the other powerline device you wish to connect.
This must be done within 120 seconds of pressing the Security/Reset button on the
left side of adapter.
6.
Check the lights on the two powerline devices. The PLC LED should be blinking
while the devices are connecting. Several times PLC and Ethernet LED blink
simultaneously and the PLC LED also shows green. Wait for about one minute
while your powerline devices connect.
If the PLC LED does not blink when you press Security/Reset, you have probably
pressed the Security/Reset button for too long. Try again, pressing the Security/Reset
button for 1 second.
If the PLC LEDs on both powerline devices do not light up, the powerline devices are
not connected. Repeat steps 4 and 5 in this section.
If that doesn’t work, see the Troubleshooting for suggestions
Security/Reset
button press
1 second
Security/Reset button
press 1 second
within 2 minutes
