AX030-0090 Turntable
AX030-0090-MANUAL | 7
VI. Operation (Cont.)
Interval
Inspection
Corrective Action
1 Year
Center bearing grease fitting
Grease bearing as necessary
Besides operating the table from the control stand, a remote (hard-
wired) pendant will allow the operator to rotate the table from a
location up to 45-50 feet away from the control stand. The remote
pendant can be seen on the right, with the same forward/reverse
switch as you find on the control stand.
NOTE: DO NOT attempt to rotate table from both the remote
pendant switch and the control stand at the same time.
VII. Maintenance
How to Gain Access to Components
Using the exploded view below, the stack up of components is in the following order:
The scale mounts to the welded pad (3/4-10 hex-head bolt), then there is a ¾-in. shim
plate attached to the top of the scale. The bearing is also bolted on via the bolts that
hold the shim to the top of the scale (5/8-11 hex-head bolts). Then the table bolts to
the top of the bearing (5/8-11 flat-head bolts), and finally the access panel is bolted to
the table top (5/8-11 flat-head bolts).
Turntable access panel
Turntable
Bearing
Shim Plate
Scale
Pad
