Digital Display Manual
6
A MCU can power up to 10 displays totaling 700 feet (ie. 10 x70
feet = 700 feet). Additional displays can easily be purchased from
your WeatherBug Representative by calling 1-800-544-4429.
2.3 Installing the Digital Display
Once you have chosen a site to place your Digital Display, the final installation is
relatively simple. The standard phone line must be "run" between the MCU and
the Digital Display, connected to each, and then power must be connected to the
display.
The back of the MCU has a female phone jack connector labeled "Display". Plug
one end of the phone line into that connector. The back of the Digital Display
also has a female phone jack labeled "Data Logger / MCU". Plug the other end
of the phone line into that connector.
To connect the power to the Digital Display, first plug the power jack into the
receptacle labeled “Power” on the back of the display. Then plug the power pack
with the standard 2 prong connector into a standard 110 volt outlet. This will
activate the Digital Display. If the MCU and sensors are operating, real time
values from the MCU should be displayed.
With the exception of maximum and minimum wind speeds, the Digital Display
tracks and stores daily highs and lows. On the first day of operation the daily
highs and lows will be those that occur subsequent to initial power up of the unit.
Daily highs and lows will also be reset if the display’s power is removed or lost
during operation.