AWE Corona Discharge CD10, Инструкция по установке и эксплуатации

Страница: 12 / 30

INSTALLATION (continued)
ELECTRICAL CONNECTIONS
IMPORTANT: The CD1
0/AD is
capable of accepting input from 90 to 260 volts AC, 43 to 63 hertz
(10 only). Installations of 120 or 240 VAC, 50-60 Hz fall within this range.
The objective is to have the ozone generator come on whenever the pooi pump comes on for filtration. All local
codes must be observed.
The CD1 0/AD will accept any power cord with an lEC plug on one end. It is available with different electrical cords
to suit the differing electrical currents in different nations. The cords available from Advanced Water Engineering,
Inc. (and their corresponding part numbers and sample nations) are:
CRD900 IEC BY NEMA 5-15 Plug (USA)
CRD905 IEC by CEE 7/7 Plug (EUROPE)
CRD910 IEC BY BS 1363A PLUG (BG, HONG KONG, SINGAPORE)
CRD915 IEC BY AS3112-1990 PLUG (AUSTRALIA, NZ)
CRD 920 IEC BY ASEV 1011 TYPE 12 PLUG (SWITZ)
Plug the lEC end of the cord into the CD10/AD unit and the other plug end into a standard wall socket to supply
power to the unit. IMPORTANT: The power source selected must be continuously energized. The air dryer portion
of the CD10/AD unit must have continuous power in order to supply dry air.
EXTERNAL CONTROL LOOP ELECTRICAL CONNECTIONS
The CD10/AD is to be used with an external controller (such as an ORP controller, pump, or timer) wire the
controller signal to the external control dry contact plug on the bottom of the CD10/AD unit as shown in the
illustration below. A single pole single throw (SPST) normally open relay should be used. A single pole
double throw (SPDT) can be used if desired. Be sure to use the correct relay coil voltage based on the
signal voltage (i.e. 24V, 1 20V, 240V).