INSPECT YOUR LOG
Never attempt to split logs containing nails, wire or debris. Always make sure that both ends
of the log you are splitting are cut as square as possible. This will prevent the log from slid-
ing out of position while under pressure. Branches must be cut of flush with the trunk.
DO NOT FORCE THE APPLIANCE.
It will do a better and safer job at its design rate. Never try to split logs larger than those
indicated in the specifications table. This could be dangerous and may damage the machine.
Don’t use log splitter for a purpose for which it was not intended.
DO NOT OVERREACH.
Never stand on log splitter. Serious injury could occur if the tool is tipped or if the cutting
tool is unintentionally contacted. Do not store anything above or near the log splitter where
anyone might stand on the tool to reach them.
AVOID INJURY FROM UNEXPECTED ACCIDENT.
Always pay full attention to the movement of the wedge ram. Never attempt to load the log
splitter while the ram is in motion. Keep hands out of the way of all moving parts. Never try
to split two logs on top of each other. Do not remove a jammed log with your hands
.
PROTECT THR ENVIRONMENT.
Take used oil to an authorized collection point or follow the stipulations in the country where
the log splitter is used. Do not discharge into drains, soil or water.
TECHNICAL DATA
Engine
230V
~
50Hz, 3000W, IP54
Splitting force
7 t
Splitting length
580/770/1060
mm
Splitting diameter
70–400 mm
Hydraulic pressure
24.5 Mpa
Hydraulic Oil Capacity
4 l
Height
1510 mm
Width
480 mm
Length
710 mm
Weight
102 kg
ELECTRICAL REQUIREMENTS
The log splitter should be connected to standard 400V+10% / 50Hz+1Hz. Electrical supply
which has protection devices of under-voltage, over-voltage, over-current as well as a resid-
ual current device (RCD) which maximum residual current rated at 0.03A.
