AW BREATH-CLEAN PAPR, Инструкция по установке, эксплуатации и ремонту

Страница: 15 / 22

15
GRIND SELECTION
➢
Press WELD/GRIND button (26) repeatedly until icon 3 appears on the screen and the red light beside the
button flashes. Additionally, icon 8 will show shade 4.
Note: Do not weld in the Grind mode, the ADF will not darken.
MEMORY SETTING
3 most frequently used setting can be stored and reactivated easily by using the 3 MEMORY buttons (27) on the right
side of the screen.
Upon use of this helmet, the last ADF settings will be stored automatically (stored about 5 minutes after). The next
time when you start to weld, the last settings will be automatically re-activated.
➢
If you want to store a completed welding setting, press and hold one of the memory buttons and stop
pressing when the icon 9 stops flashing.
➢
To activate the stored memory, press the memory button.
Note: only in welding status you can activate the memory. Change to welding if you are currently using the grinding
function.
MAINTENANCE AND STORAGE
PAPR MAINTENANCE
The Respiratory system unit must be checked regularly and must be changed if it is damaged and cause leakage.
The filter must be changed if it is broken, or it is blocked and does not give sufficient airflow.
The breathing tube must be changed if it is broken or kinked
The battery must be charged when the low battery alarm rings.
Use a soft cloth to wipe the external surfaces. Don’t use water!
The filter should be replaced together with the pre-filter.
ADF AUTO DARKENING LENS
BATTERY INDICATOR
Icon 1 indicates the battery status. Replace the battery when it is low, otherwise, the ADF switching time will become
slower and shade accuracy will be compromised.
POWER SUPPLY AND REPLACE THE BATTERY
The power of the auto-darkening helmet is provided by solar cells and 1pcs of CR2450 lithium battery.
When change the battery, open the Battery holder (19) at the side of the ADF and replace the battery (20).
STORAGE
The Respiratory system must be stored in a dry, clean area, in the temperature range of -10
℃
to +55
℃
and relative humidity less
than 90%RH.
If the equipment is stored at temperature below 0
℃
, the battery must be allowed to warm up to achieve full battery charge. The
equipment must be protected from dust, particles and other contamination.
If the equipment is not used for a long time, the battery should be fully charged, removed from Respiratory system unit and stored
separately.