CAMERA PARAMETERS
On the DVR, right-click to show the main menu, and go to “ADVANCED CONFIG”
“DCCS”.
In “DCCS”, select the channel which connects this camera, and click “SETUP” to enter the menu of camera
parameters.
ADVANCED CONFIG
CAMERA
CH1 CH2 CH3 CH4
DETECTION
MENU SETUP
ALERT
NETWORK
DISPLAY
RECORD
DCCS
NOTIFY
DEVICE AVT503S
MULTICASTING
CONNECTION OK
EXIT
Item
Description
BRIGHTNESS
Click the current value to manually adjust the brightness of the image. The higher the value,
the brighter the image.
CONTRAST
Click the current value to manually adjust the contrast of the image. The higher the value,
the higher the contrast ratio.
HUE
Click the current value to manually adjust the hue of the image.
SATURATION
Click the current value to manually adjust the saturation of the image. The higher the value,
the more saturated the image.
CAMERA GUARD
Enable “GUARD LOCK” to temporarily disable the pan function of this camera and fix the
camera surveillance area.
For details, please refer to the section “
CAMERA GUARD
”.
SEQUENCE
Configure a sequence group for area patrol.
For details, please refer to the section “
MOTORIZED PAN AND SEQUENCE SETUP
”.
WHITE BALANCE
Process the current image to retain color balance over a color temperature range.
The options are: Auto, 2500K, 3200K, 4200K, 5800K & 9500K.
SHARPNESS
Sharpness enhances the clarity of image detail by adjusting the aperture and sharpening the
edges in the pictures.
Hold and drag the slider to adjust the level of sharpness. The higher the value, the sharper
the image.
SLOW SHUTTER
Slow shutter is used to increase the exposure time to get clearer image, for example, at night.
The options are: AUTO, 1/15 and 1/6.
MIRROR
Select “ON” to rotate the images horizontally based on your installation situation when
necessary.
FLIP
Select “ON” to rotate the image 180° when necessary.
DENOISE
Click and drag the slider to adjust the level from 0 ~ 10 to decrease the noise shown in the
dark environment.
EXPOSURE VALUE
Drag the slider to adjust the exposure level from 0 ~ 4.
WIDE DYNAMIC RANGE
Wide Dynamic Range (WDR) is used when users need to increase image recognizability in
overexposure and dark areas.
The options are: LOW / MIDDLE / HIGH / OFF
FIXED SHUTTER
Shutter Speed is a function that can adjust the duration of the electronic shutter to produce
optimum image quality. Select the shutter speed suitable for your environment.
DEFOG
Select “ON” to enable the defog function in poor weather conditions such as fog, smog or
smoke. The captured image can be improved.
IR CONTROL
Select “Auto” to automatically enable IR LEDs at night or in the dark environment, or “OFF” to
disable this function.
IR TURN ON LEVEL
Select the level for IR light to activate. 0 ~ 20
IR EXTEND TIME
Configure from 0 ~ 60 seconds to delay the switch of the IR mode at night, or select “0” to
disable this function.
This is used for the environment where the light condition may change suddenly and usually
last for a short time, for example, the entrance of a parking lot. It may cause the day & night
mode switching constantly and damage the camera.
With this function, the camera will delay the mode switch at night since the light change is
temporary and unnecessary to pay attention.
RESET DEFAULT
Click to reset all camera settings to their default values.
REBOOT THE SYSTEM
Click to reboot the camera if necessary.