SPECIFICATIONS
Model:
AV-1030-B
GPIB and RS-232 control:
yes
Amplitude (to 50 Ohms)
1
:
0 to ±5 Volts
Output impedance:
50 Ohms
Rise time (20%-80%):
≤ 300 ps
Fall time (80%-20%):
≤ 350 ps
Pulse repetition frequency (PRF):
1 Hz to 10 MHz
Pulse width:
10 ns to 1 ms
Required load impedance:
50 Ohms
Jitter (Sync out to pulse out):
≤ ± 25 ps ± 0.01 % of sync delay
Polarity (main output):
Positive or negative (switch-selectable)
Duty cycle (max):
10 %
Waveform aberrations:
Overshoot, undershoot, ringing and slope aberration are less than ± 10% at
amplitudes of 0.5V and higher
1
with outputs terminating in 50 Ω.
Trigger required (Ext trig mode):
+ 5 Volts, ≥ 4 ns TTL
Trigger required (Gate in):
0 to 0.8 V (or grounded): No output
+ 2.8 V to + 5.0 V (or open): Normal output
Minimum propagation delay:
(Ext Trig In to Main Out)
< 100 ns
Sync delay:
(Sync Out to Main Out)
0 to ± 1 ms
Sync output:
+3 Volts, 50 ns, will drive 50 Ohm loads
Single pulse mode:
Manual Push Button
Signal connectors:
Main output: SMA
Other: BNC
LabView Drivers:
-B units only: check
http://www.avtechpulse.com/labview
for availability and downloads
Power requirement:
100 - 240 Volts, 50 - 60 Hz
Dimensions (H x W x D):
100 mm x 430 mm x 375 mm (3.9” x 17” x 14.8”)
Weight & chassis material:
4.5 kg (10 lb.), anodized aluminum, with blue plastic trim
Mounting & Temperature range:
Any, +5°C to +40°C
1) For operation at amplitudes of less than 5% of maximum, best results will be obtained by setting the amplitude near maximum and
using external attenuators on the output.
6
Содержание AV-1030-B
Страница 42: ...PERFORMANCE CHECK SHEET 42...
