IP65 Garden Lasers User Manual
Assembly
Remove all components from packaging (save the packaging for storing the garden
laser when not in use)
Choose the intended surface which the laser light will project onto.
Determine the projection location of the unit for installation and ensure it is free
from any visual obstructions.
Push the spike into the ground (depending on the firmness of the ground, you may
need to use a mallet to insert the spike completely. Do not use your foot!)
Attach the angle adjustment bracket to the bottom of the laser as shown above (A).
Use the correct screw to fix bracket (B).
Screw the angle adjustment bracket to the ground spike using the correct screw (C).
Adjust the angle of the laser head (D).
Attach the 2-pin lead to the AC power adaptor (E). This will only go in one-way, do not force the connector.
Once the 2-pin lead has been fully inserted, screw the cap into place to ensure a weatherproof seal.
Plug the AC adaptor into the mains to start the laser light.
With great care and avoiding looking directly at the laser adjust the angle to the required position. Tighten all screws if required.
Remote Control
The remote has an effective range of 15 metres (50 feet). This will be reduced if there are obstacles. Only the speed settings of the
laser unit will be saved if you disconnect the unit from the mains or switch off via the power button on the remote.
All settings will be saved automatically if you are using the timer settings to switch off the unit. It will start up on the same program as
when the timer which the unit off. Take care not to lose the
remote, it’s the only way you have of adjusting
the laser unit!
1.
Power button
–
Start or Stop the laser (unplug power if not being used for long periods)
2.
Continuous Speed
–
6 different rotational speeds available (including static).
3.
Step Speed
–
6 different speed/step settings.
4.
Colour
–
Select a single colour or a combination of colours.
5.
Flash
–
3 settings.
6.
Timer
–
The timer will automatically switch off after the duration selected. The unit will automatically
switch on at the same time the following day. E.G. If you get you set the timer at 5pm for 6 hours, the
laser will switch off at 11pm and switch on again at 5pm the following day. Pressing
“
CANCEL
”
will
cancel the timer setting so the laser unit can be switched on/off manually.
Activating the remote
–
A CR2025 battery is already in your remote unit. Remove the plastic insulation tab.
This will enable the remote to work. If the remote isn’t g
oing to be used for a long period of time, it is
advisable to reinsert the plastic tab to save battery life.
Helpful Hints
•
Do not use with dimmers.
•
For extended lifetime, let the unit cool down for 30 mins every 6 hours.
•
Operating temperature are between -20°C and 35°C. There may be a longer warm-up time in low temperatures.
•
The laser will look brightest in the dark but will be less bright if competing with another light source.
Specifications
Power supply
12Vdc, 500mA (adaptor supplied)
IP rating
IP65
Warm up time
2 - 5 minutes
Laser class
3R
Power lead length
4.8m
Housing material
Aluminium
Operating temperature range
-20 to 35°C
Dimensions
100 x 100 x 130mm
Weight
1kg
Laser safety standard
BSEN62471:2008
Disposal:
The “Crossed Wheelie Bin” symbol on the product means that the product is classed as Electrical or
Electronic equipment and should not be disposed with other household or commercial waste at the end of its useful life.
The goods must be disposed of according to your local council guidelines.
Errors and omissions excepted.
Copyright© 2017. AVSL Group Ltd.
