Page 2
ANTENNA MOUNTING
For maximum operational range the antenna must be made vertical and straight.
PROGRAMMING
The RX-Pro will need to be reset and a remote coded in to program and use the unit.
RE-SETTING THE AVS RXPRO
Re-setting erases all remotes and detectors and returns the programming settings to the factory defaults .i.e. 1 second
pulse outputs for all channels.
1.
Disconnect power from the unit.
2.
Using a piece of wire or metal tweezers, short (link) the top
solder pad on the far right channel LED to the square bottom
solder pad on the bottom right hand corner of the circuit
board as shown. Keep the short on.
3.
Press and hold button 1 on the remote control.
4.
Power up the unit and then remove the short.
5.
When the channel lights go solid release the button on the
remote control. The device has now been reset, and the first
remote control is learnt in. You may now learn additional
remotes as per the standard procedure.
MANUAL SYMBOLOGY
Light is
OFF
Light is
ON
and not flashing
Light is
FLASHING
Lights are
SCROLLING
When looking at the receiver with the terminal strip at the bottom:
The group of 3 LEDs on the left are the
FEATURE
lights
The group of 4 LEDs on the right are the
CHANNEL
lights
NOTE:
During normal operation the display lights on the unit are scrolling from right to left. When the display lights are
not scrolling, this indicates the unit is in programming mode.
FEATURE
CHANNEL
