NOTE:
Actual application may vary slightly from illustrations.
Installation Steps
3
Locate the hex screw studs along the underside that
attaches the top of the grill to the hood. Loosen, but do
not totally remove the screws.
Lower the hood, and pivot the grill forward to create
a 1/8” (.32 cm) gap between hood and grill.
4
Silde the hood shield between the hood and grill
and center. Replace and retighten previously
loosened hex screws.
5
6
7
8
9
10
Remove side marker light by removing
the (1) screw directly underneath the
light and sliding light forward..
9.5” (24 cm)
Place (1) bump-on on the leading edge of the
fender above headlight 9.5” from edge of grill.
Fender Protector
Installation
Headlight
Page 2 of 3
Slide the headlight tab behind the main headlight
assembly.
Headlight tab
Tab should be positioned snugly behind headlight
assembly.
It is necessary to expose the sheet metal flange of
the hood by releasing the rubber seal nearest the
grill. Discard the (2) plastic fasteners.
