AVS 4406037, Руководство по установке

Страница: 25 / 35

AVS A-SERIES INSTALLATION MANUAL - GEN 2 VER 5
25
Turbo timer instructions
The system has two turbo timer features. Firstly it has its own on-board turbo timer system, and secondly it
has an interface so is compatible with external turbo timers.
On-board turbo timer
On most vehicles the AVS A-Series can be set up to run the on-board turbo timer by simply connecting the
ignition immobiliser wires that would normally be connected to the key side of the cut (IM2A) to +12V main
power feed as shown in the diagram below.
The IGN sense wire remains on the key side of the ignition wire while the remaining immobiliser wires (IM2B)
are connected to the engine side of the ignition wire. Many vehicles have dual ignition wires to run cooling
fans. You must ensure the cooling fans continue to run when the vehicle is running on the turbo timer, you
may need to hook up the second ignition wire relay as per next page. Note: IM2A MUST BE CONNECTED TO
+12V MAIN POWER FEED.
Wiring instructions:
How to set up the on-board turbo timer:
1. Install the alarm as normal except connect the ignition immobilisers and IGN input to the alarm as shown
in the diagram.
2. Ensure all doors, bonnet and boot are closed.
3. Turn the ignition on, off and on then press the button 16 times. The indicators, LED and siren will
flash or chirp upon each press of the button.
4. Now turn the ignition off. The siren should chirp the current run time setting to indicate that the
programming mode has been entered.
Number of chirps Turbo timer run time
1 1 minute
2 2 minutes
3 4 minutes