17
Continuous Drainage
-
When you plan to leave this unit unused for a long time, please remove the rubber blockage
from the drainage hole at the bottom of unit, and drain all water outside.
-
You can use the continuous drainage with a drainage hose connected to the bottom drain hole,
when the unit working at the HEAT mode.
-
The continuous drainage is not need to be applied when the unit working at the COOL or
DEHUMIDIFY mode. The unit can evaporate the condensate water automatically by the
splash motor. Make sure the drainage holes are stemmed well.
-
If water splash motor is damaged, continuous drainage can be used. To connect the drain
hose to the bottom drain hole (
Fig.6
), the unit can also work well.
-
If splash motor is damaged, intermittent drainage can also be used. Under this condition, when
the water full indicator lights up, please connect a drain hose to the bottom drainage hole, then
all the water in the water tank will be drained outside. The unit can also work well.
7. Installation Explanations
1. Installation Explanations:
-
A removal air-conditioner shall be installed in the flat and empty place all around. Don’t block
the air outlet, and the required distance around should be at least 30cm. (
See Fig.3
)
-
Should not be installed in wet location, such as the laundry room.
-
Socket wiring should be in accordance with the local electric safety requirements.
Fig.3
2. Introduction to Exhaust Hose Installation
A) Temporary installation
7. Installation Explanations
