Avocent Eletric Keyboard, Инструкция по установке и эксплуатации, Страница: 23 / 34

Chapter 3: Operations
17
System Control
The following is a summary of all operational commands.
SYSTEM CONTROL KEY SEQUENCES
Key Sequence Action
<CTRL> <CTRL> Addr <Enter> Selects an active channel via keyboard.
<CTRL> <CTRL> D nn <Enter> Configures the dwell time. Substitute nn with a value
from 2 to 60 seconds.
<CTRL> <CTRL> SG <Enter> Enables the scan Go command.
<CTRL> <CTRL> SH <Enter> Enables the scan Halt command.
<CTRL> <CTRL> M+ <Enter> Mouse will suspend scanning.
<CTRL> <CTRL> M- <Enter> Mouse will not suspend scanning. (default)
<CTRL> <CTRL> MR <Enter> If you hot-plug the SwitchView to a PC connection
you may experience a loss of mouse signal. Use
this command to restore the signal if you’re using a
standard PS/2 mouse driver.
<CTRL> <CTRL> MW <Enter> Use this command to restore the mouse signal if
you’re using a PC with a Microsoft IntelliMouse driver.
<CTRL> <CTRL> K n <Enter> Sets keyboard scan set; n is a number 1 - 3.
<CTRL> <CTRL> AV <Enter> Displays the current firmware version of the
SwitchView processors. You must be either at a
DOS prompt or in a text editor/word processor to
view this information.
<CTRL> <CTRL> H1 <Enter> Default Command Mode Activitation.
<CTRL> <CTRL> H2 <Enter> Changes the Command mode activation sequence
to <Alt> <Alt>.
<CTRL> <CTRL> H3 <Enter> Changes the Command mode activation sequence
to <Shift> <Shift>.
SYSTEM CONTROL KEY SEQUENCES (CONT.)
Key Sequence Action
<CTRL> <CTRL> H4 <Enter> Changes the Command mode activation sequence
to <NUMLOCK> <->.
<CTRL> <CTRL> ZM <Enter> Resynchronizes the mouse.
<CTRL> <CTRL> SSON <Enter> Enables SmartSwitch Command, where only
powered channels can be selected.
<CTRL><CTRL> SSOFF <Enter> Disables SmartSwitch Command, allowing user to
switch to non-powered channels. Use this to select
a laptop.