Avocent AutoView 2000, Инструкция по установке и эксплуатации

Страница: 16 / 52

10
AutoView 2000 Installer/User Guide
CAUTION: Rack Loading - Overloading or uneven loading of racks may result in shelf or rack
failure, causing damage to equipment and possible personal injury. Stabilize racks in a
permanent location before loading begins. Mount components beginning at the bottom of the
rack, then work to the top. Do not exceed your rack load rating.
To install the 1U switch mounting bracket: (kit sold separately)
1. Remove the fi rst two screws on each side.
2. Line up the holes in the “long side” of the kit’s side brackets with the
screw holes in the switch.
3. With a Phillips screwdriver, fasten the mounting brackets to the switch
using two screws on each side.
4. Attach four cage nuts or clip nuts to the rack mounting fl ange of the rack
cabinet so that the nut is positioned on the inside of the rack.
NOTE: Nuts are not included with the rack mount kit.
5. Mount the switch assembly to the rack cabinet by matching the holes in
the “short side” of each bracket to an appropriate set of matching holes on
your rack cabinet. Next, insert the combination hex head screws through
the slots in the bracket and the holes in the mounting rail, then into the
cage nuts or clip nuts.
Installing the AutoView 2000
Plug the supplied power cord into the back of the appliance and then into an
appropriate power source. Figure 2.2 illustrates one possible configuration for
your AutoView appliance. See the following detailed set of procedures to
successfully install your appliance.
CAUTION: To reduce the risk of electric shock or damage to your equipment -
- Do not disable the power cord grounding plug. The grounding plug is an important safety feature.
- Plug the power cord into a grounded (earthed) outlet that is easily accessible at all times.
- Disconnect the power from the unit by unplugging the power cord from either the electrical
outlet or the unit.