Avocent AMX Switch Series, Инструкция по установке и эксплуатации

Страница: 85 / 236

Chapter 4: Terminal Operations 73
SNMP Configuration
The SNMP Configuration option on the Terminal Applications menu enables you to specify the
following parameters for SNMP processing:
• Enabling and disabling SNMP
• Defining read, write and trap community names
• Defining and deleting up to four trap destination IP addresses
• Enabling and disabling SNMP traps
NOTE: “Trap” refers to a trap command used by manual devices to report events to the Network Management
System (NMS).
To configure SNMP processing:
1. On the Serial Console Main Menu, press 4 to select SNMP Configuration. The SNMP
Configuration Menu displays.
2. Press
1
and
Enter
to toggle the SNMP mode from Disabled to Enabled.
3. Press 2 and Enter to specify the community to which traps will be read. Enter the community
name and Enter .
4. Press
3
and
Enter
to specify the community name to which traps will be written. Enter the
community name and press
Enter
.
5. Press 4 and Enter to specify the trap community name. Enter the trap community name and
press Enter .
NOTE: The read, write and trap community names must match those used by the SNMP Browser/Trap Logger.
6. Press
5
,
6
,
7
,
8
and
Enter
to specify each trap IP address of up to four trap hosts to which you
want to send SNMP traps. Type each trap IP address and press
Enter
.
NOTE: The trap destination address must take the format of a decimal IP address as follows: xxx.xxx.xxx.xxx
7. Press
9
and
Enter
to display the SNMP Trap Configuration Menu. Press the number of each
SNMP trap you wish to enable or disable and
Enter
.
8. Press 0 and Enter to apply and store all changes.
- or -
Press x and Enter to restore settings as they were before changes were made.
See Users on page 43 and Forcing a connection using SNMP on page 69 for information on adding
an SNMP user and assigning rights to the SNMP user.