Page 13
Figure 6
– QSPI/Flash Boot Mode
Boot Linux
8. If previously disconnected, plug in the micro-USB cable to the USB-JTAG/UART port.
9. Plug in the 2
nd
micro-USB cable to the auxiliary power port. This is necessary for the USB
thumb drive to get power.
10. Launch and connect Tera Term using the settings shown below. Press the
RESET
button
(SW2) to reset the board so you can see the boot sequence.
Figure 7
– COM Port Settings for USB-UART Terminal
Содержание MiniZed
Страница 9: ...Page 9 Figure 2 MiniZed Block Diagram ...
Страница 21: ...Page 21 Figure 16 MiniZed FTP Session ...