AVM OVATION PA 8.3, Руководство по эксплуатации

Страница: 13 / 44

Basic operation
OVATION PA 8.3 | 9 |
Please note: The device is not entirely disconnected
in standby mode. To disconnect completely, press
t he m a i ns s wi t c h on t h e rea r p a n el ( 1 2 ) or d i s
-
connect the power cable from the mains connector
(11).
2.1.0.1 Phase LED
A glowing phase LED on the back (15) indicates an
incorrect phase. Therefore, make sure the phase
LED does not light up after switching on the device
for the first time. Otherwise change the phase posi
-
tion, e.g. by turning the mains plug to the power
socket.
2.1.0.2 Tube warm-up
I f a n o p t i o n a l T U B E O U T c a rd i s i n s t a l l e d , t h e
switch-on process will take about 30 seconds due to
the required tube warm-up time. Please wait until
the entire display
waiting for tube warmup changes
completely from lower case to uppercase and then
goes out. The device is now ready for use.
Without a TUBE OUT card installed, the switch-on
proc ess ta kes approx. five seconds. The display
shows a corresponding countdown during this time.